Projector Alignment - PEERLESS ELPMBPRG - Advanced Projector Ceiling Mount Installation And Assembly Manual

Projector Alignment

To adjust yaw (swivel) for extension column installation: Loosen screw on projector mount assembly (A)
6
indicated below until projector mount can be rotated. Rotate mount to desired position and retighten screw.
To adjust pitch (forward and backward tilt): Turn knob on back of mount as shown below. Pull knob out and turn
by hand for easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
To adjust roll (side to side tilt): Turn knob on side of mount as shown below. Pull knob out and turn by hand for
easy adjustment or insert #2 phillips screwdriver in end of knob and turn.
6-1
To prevent tampering with the pitch and roll adjustments: Tighten the two tamper resistant security screws
on the projector mount assembly using 4 mm security allen wrench (J) to lock the pitch and roll adjustments as
shown below.
NOTE: Tighten screws firmly, but do not overtighten. Overtightening can damage the mount.
• Do not adjust pitch or roll while tamper resistant security screws are fully engaged.
• Loosen the two tamper resistant security screws one complete turn before adjusting the projector mount assembly or
damage may occur.
FRONT VIEW
Visit the Peerless Web Site at www.peerlessmounts.com
ARROW INDICATES
FRONT OF MOUNT
SCREW FOR SWIVEL STOP
CAUTION
TO LOCK ROLL TIGHTEN
TAMPER RESISTANT
SECURITY SCREW
11 of 12
For Technical Support Contact Peerless Mounts at 1-800-729-0307 or 708-865-8870.
A
KNOB FOR PITCH
ADJUSTMENT
BACK OF MOUNT
KNOB FOR ROLL
ADJUSTMENT
TO LOCK PITCH TIGHTEN
TAMPER RESISTANT
SECURITY SCREW
SIDE VIEW
ISSUED: 04-01-08 SHEET #: 055-9254-3 05-29-08