Advertisement
Note: Please check the motherboard manual for the USB header pin layout and
make sure it matches the attached table. If it does not match this Intel standard,
please call Antec customer support at (800) 22ANTEC (North America) or at
+31 (0) 10 462-2060 (Europe) to buy a USB adapter. This adapter will allow you
to connect the front USB to the motherboard on a pin-by-pin basis.
1
2
9
10
Connecting the IEEE 1394 (FireWire®, i.Link®) Port
You will find a single 10-pin connector on a cable attached to the front IEEE 1394
connection. This is an Intel standard connector, which is keyed so that it can't be
accidentally reversed as long as it is connected to a proper Intel standard
motherboard header. Connect the 10-pin connector to the motherboard header so
that the blocked pin fits over the missing header pin.
Note: Please check the motherboard manual for the IEEE 1394 header pin layout
and make sure it matches the attached table. If you intend to connect the front
FireWire® port to an IEEE 1394 add-on card that comes with an external-type
IEEE 1394 connector, please call Antec customer service at (800) 22ANTEC
(North America) or +31 (0) 10 462-2060 (Europe) to buy an adapter. This adapter
will allow you to connect the front IEEE 1394 port to the external-type connector.
Pin Assignment for Front Panel IEEE 1394 Connector
1
2
9
10
Connecting the Audio Ports
There is an Intel standard 10-pin connector (with 7 individual wires with
connectors) coming out from the front panel speaker and microphone connection.
If the motherboard supports Intel's standard onboard audio connector, you can
plug in the 10-pin connector directly onto the board. For non-Intel standard audio
connection, you need to plug the 7 individual connectors to the motherboard.
See instruction below:
Motherboard Pin Layout
Pin
Signal Names
1
USB Power 1
3
Negative Signal 1
5
Positive Signal 1
7
Ground 1
9
Key (No Connection)
Pin
Signal Names
1
TPA+
3
Ground
5
TPB+
7
+12V (Fused)
9
Key (No Pin)
Pin
2
4
6
8
10
Pin
2
4
6
8
10
3
Signal Names
USB Power 2
Negative Signal 2
Positive Signal 2
Ground 2
Empty Pin
Signal Names
TPA–
Ground
TPB–
+12V (Fused)
Ground
Advertisement
