Power Indicator Lights Green Or Orange/Flashes Green Or Orange - Epson EMP-732 User Manual

Problems Solving
Status
Lamp replacement notification
Orange

Power indicator lights green or orange/flashes green or orange

Status
Standby condition
Orange
Warm-up in progress
Green
Projection in progress
Green
Cool-down in progress
Orenge
TIP
•If the projector is not operating properly even though the indicators are all showing normal, refer to "When the Indicators Provide No Help"
on the following page.
•If an indicator is showing a status which does not appear in the previous tables, contact your dealer or the nearest address provided in the
"International Warranty Conditions" section of the Safety Instructions/World-Wide Warranty Terms booklet.
Cause
Replace the lamp with a new one.
If you continue to use the lamp after it has passed the replacement period, the possibility that the
lamp may break will increase. Replace the lamp with a new one as soon as possible. The Power
indicator status will vary depending on the projector status at the time.
Cause
Projection starts again when the [Power] button is pressed.
You can disconnect the power plug from the electrical outlet when the status light is in this
condition.
Warm-up time is approximately 40 seconds. After warm-up is complete, the indicator stops
flashing.
Please wait.
•The cool-downg
•The [Power] button will not operate if it is pressed while cool-down is in progress. When the
cool-down period is finished and the confirmation buzzer has sounded and the indicator changes
to light orange, repeat the operation.
Remedy or Status
sp.101
Normal
Remedy or Status
period lasts about 20 seconds.
User's Guide
77
: lit : flashing : off
: lit : flashing : off