Epson EMP-732 User Manual page 86

Problems Solving
Image colours are not right
Check
Do the input signal settings match the signals
from the connected device?
Has the image brightness been adjusted
correctly?
Are the cables connected correctly?
Has the image contrastg
correctly?
Has the colour been adjusted correctly?
Have the colour intensity and tint been
adjusted correctly?
Only when projecting images
from a video source
If you connect a computer or RGB video to the [Computer/Component Video] port, and select
"Component Video" for "Computer Input" in the configuration menu, the projected image is tinged
with purplish red.
If you connect a
"Computer" for "Computer Input" in the configuration menu, the projected image is tinged with
green.
Select the correct signal format for the connected source.
"Signal" - "Computer Input" sp.60,
If a component videog
menu command to select the video signal format.
"Signal" - "Video Signal"
Use the "Brightness" menu command to adjust the brightness.
"Image" - "Brightness" sp.56,
Check that all of the cables required for projection are securely connected. sp.20–
been adjusted Use the "Contrast" menu command to adjust the contrast.
"Image" - "Contrast" sp.56,
Use the "Color Adjustment" menu command to adjust the colour.
"Image" - "Color Adjustment" sp.57,
Use the "Color Intensity" and "Tint" menu commands to adjust the colour and tint.
"Image" - "Color Intensity", "Tint"
Remedy
component videog to the [Computer/Component Video] port, and select
p.61
or S-Videog source is connected to the projector, use the "Video Signal"
sp.61
p.58
p.58
p.59
sp.58
User's Guide
85
p.26