Epson EMP-732 User Manual page 91

Problems Solving
EMP NS Connection starts, but a projector is not found
Check
Is the wireless or wired LAN card inserted?
Is the network cable connected correctly?
When connected to a wired LAN
Is the access lamp of the wireless LAN card
that is inserted into the projector lit green?
Is the projector displaying the EasyMP
configuration menu screen?
Is the computer ready for LAN card or in-built
LAN functionality to be used?
Is the wireless LAN setting for the computer
set to ad hoc modeg?
When connected to a wireless
LAN in easy connection mode
Is the DHCPg function of the wired LAN set to
"ON"?
When connected to a wireless LAN
Has the network adapter been selected
correctly in EMP NS Connection?
If making a wireless LAN connection, are
there any settings within the power saving
features of your computer which disable the
wireless LAN?
Is the computer's radio wave setting for the
wireless LAN set to low-intensity?
Check that the wireless or wired LAN card is correctly inserted into the card slot of the projector.
"Inserting and Removing Cards"
Check that the network cable is connected correctly. If it is not connected or is connected
incorrectly, reconnect it.
If the access lamp is off, remove the wireless LAN card and re-insert it.
"Inserting and Removing Cards"
Network connections are disabled while the EasyMP configuration setting screen is displayed.
Close the configuration settings to return to the EasyMP standby window.
Check whether the LAN device is functioning in the Device Manager. For example, "Control panel" -
"System" - "Device Manager".
Change the wireless LAN settings at the computer to ad hoc mode.
s"Computer Wireless LAN Settings" in the EasyMP Network Setup Guide
Depending on the manufacturer of the wireless LAN card, you may be able to use a communication
setting utility (such as Client Manager) to set ad hoc mode.
"Ad hoc mode" may be expressed using some other terminology such as "Computer communication
using wireless LAN (WiFi)", "Wi-Fi ad hoc", "802.11 ad hoc", "802.11 Mode Connection" or "Peer
to Peer".
Set the DHCP setting of the wired LAN to "OFF" in the EasyMP configuration setting screen.
s"Connecting in Access Point Mode or Wired LAN Mode" in the EasyMP Network Setup Guide
If the computer that you are using has several LAN environments, the correct network adapter to be
used by EMP NS Connection must be selected, otherwise it will not be possible to connect. Start
EMP NS Connection and select the network adapter from the "Extension" - "Switch LAN"
(Windows) or "Extension" - "Network Set" (Macintosh) menu.
Please enable the wireless LAN.
Change the radio wave setting to the highest possible intensity.
Remedy
sp.17
sp.17
User's Guide
90