Tm Auto Dry; Control Panel And Features - Kenmore 6002 Use & Care Manual

Norma
CONTROL PANEL AND FEATURES
T 7
Medium
Off On Casual Off 011
WRINKLE GUARD DRYTEMP PUSH to START
60 50 40
2O -- Touch Uo
I,o
O
START
Not all features and options are available on all models.
Appearance may vary.
@
O
DRYER CYCLE KNOB
Use your Dry Cycle [<nob to select available cycles on your
dryer. Turn the knob to select a cycle for your laundry load.
See "Cycle Guide" for detailed descriptions of cycles.
Time Dry
Will run the dryer for the specified time on the control.
On models with a se[ectab[e temperature knob_ you may
choose a setting based on the fabrics in your load. Drying
time and temperature will depend on your dryer model.
Auto Dry
Auto Dry cycles give the best drying in the shortest time.
Drying time will vary based on fabric type, load size, and
dryness setting. Some models have Auto Dry with Auto
Moisture Sensing
TM.
Air Only
Use the no heat Air Only setting to dry foam, rubber r plastic,
or heat-sensitive fabrics.
OPTIONS AND SETTINGS
Wrinkle Guard
TM
Feature (on some models)
When you are unable to remove a load of clothes from the
dryer as soon as it stops, wrinkles can form. The WRINKLE
O
O
GUARD
TM
feature periodically tumbles, rearranges, and fluffs
the load to help keep wrinkles from forming.
[] Get up to 40 minutes of heat-free, periodic tumbling at
the end of a cycle. Turn the WRINKLE SHIELD
TM
knob to
select ON or OFF at any time before the cycle has ended.
Dry Tamp (on some models)
Select a drying temperature based on the fabrics in
your load. If you are unsure of the temperature to select
for a load, select the lower setting rather than the higher
setting. See "Cycle Guide."
Cycle Signal Knob/START Button
The Cycle Signal produces an audible sound when the
drying cycle is finished. On some models, this knob is
combined with the PUSH to START button Promptly removing
clothes at the end of the cycle reduces wrinkling.
Turn the CYCLE SIGNAL knob to select the desired
setting (On or Off). With combined buttons, Press and hold
the CYCLE SIGNAL/PUSH to START button to start the dryer.
On models without the CYCLE SIGNAL, press the START
button to start the dryer.
NOTE: When the Wrinkle Guard
TM
setting is selected
and the Cycle Signal is on, the tone will sound every
5 minutes until the clothes are removed, or the Wrinkle
Guard
TM
setting ends.