Stop/Resume; Error Display; Service Mode - Hayward Super Pump® VS Owner's Manual

6.8. Stop/Resume

Screen


Note: When RUN / STOP is pressed at any time during normal operation, the above message will be displayed. The
pump will stop within several seconds, and will remain stopped until RUN / STOP is pressed a second time, at which
point the pump will resume normal operation.

6.9. Error Display

Screen

Note: If an Internal Failure has been detected the pump will turn the drive off and display the error code
corresponding to the error. As well, the Power LED will FLASH. A list of these error codes can be found in section 11.2.
The cause of the internal error should be investigated and fixed before continuing to run the pump. When the cause
of the error has been fixed, cycling power to the pump or pressing the RUN / STOP button will resume the pump.

6.10. Service Mode

Screen


Note: When troubleshooting the pump it may be useful to run the pump without other program functions. This can be
done in service mode. To enter service mode, remove power from the pump. Press and Hold DISP/FUNC and apply
power to the pump. In this mode only the motor RPM's can be changed. To exit from service mode, cycle the power to
the pump off and on.
Page 16 of 24
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Super Pump Variable Speed Pump
Buttons
Used
RUN
STOP
RUN
STOP
Buttons
Used
Buttons
Used
Press and Hold DISP/FUNC and apply
DISP/FUNC
▲▼
DISP/FUNC
Comments
Comments
Comments
power to the pump
Adjust the motor rpm of test mode
Cycle through to the next screen
IS2600VSP Rev C