M O N Indicator Is Flashing Or Lit - Epson PowerLite Pro Z8150NL User Manual

Problem Solving

m o n Indicator is flashing or lit

Status Cause
High Temp Warning (This is not an abnormality. However, if the temperature rises too high again, projection stops automatically.)
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s p.116,
Replace Lamp The lamp indicated by flashing indicator, lamp 1 or 2, is due for replacement. Replace it with a new lamp.
p.119
s
If you continue to use the lamp after the replacement period has passed, the possibility that the lamp may
explode increases. Replace it with a new lamp as soon as possible.
We recommend replacing both lamps together to maintain consistent hue and brightness of projected
images.
Lamp Warning Check the following two points.
• Remove the lamp indicated by the flashing indicator, lamp 1 or 2, and check if it is cracked. s
Supply System
Warning (Ballast)
• Clean the air filter. s
If it is not cracked: Re-fit the lamp and turn on the power.
If the error continues: Replace the lamp with a new lamp and turn on the power.
If the error continues: Stop using the projector, disconnect the power cable from the electrical outlet, and
contact Epson. s
If it is cracked: Replace it with a new lamp, or contact Epson. (Only one lamp is working. Replace the
burned-out lamp as soon as possible.). s
If replacing the lamp yourself, be careful to avoid pieces of broken glass.
When using at an altitude of 4921 ft (1500 m) or more, set High Altitude Mode to On. s
Set Direction to Pointing Down, Pointing Up, Angled Up, or Angled Down when the projector is installed
in a direction which is not horizontal. s
: Lit : Flashing
Remedy or Status
p.116
p.114
p.114
p.67
: Off : Varies according to the projector status
p.122
99
p.119
p.67