• Do not block the slots and openings in the projector case. They provide ventilation and prevent the projector from overheating. If you are setting up the

projector near a wall, leave at least 19.7 inches (50 cm) of space between the wall and the air exhaust vent.

• Do not operate the projector in a closed-in cabinet unless proper ventilation is provided.

• You may need to clean the air filter and intake vent. A clogged air filter or vent can block ventilation needed to cool the projector.

• Do not use or store the projector outdoors for an extended length of time.

• Do not use the projector outside the required temperature range (s p.203). Doing so may cause an unstable display and could lead to projector damage.

• Do not store the projector outside the required temperature range (s p.203) or in direct sunlight for long periods of time. Doing so may cause damage

to the case.

• Do not touch the plug during an electrical storm. Otherwise, you may receive an electric shock.

• Unplug the projector when it will not be used for extended periods. Place the projector near an outlet where the plug can be easily unplugged.

• Unplug the projector from the wall outlet and refer servicing to qualified service personnel under the following conditions: If it does not operate normally

when you follow the operating instructions, or exhibits a distinct change in performance; If smoke, strange odors, or strange noises come from the

projector; If the power cord or plug is damaged or frayed; If liquid or foreign objects get inside the projector, or if it has been exposed to rain or water; If

it has been dropped or the housing has been damaged.

• Except as specifically explained in this User's Guide, do not attempt to service this product yourself. Refer all servicing to qualified personnel. Opening

or removing covers may expose you to dangerous voltages and other hazards.

• Never open any covers on the projector except as specifically explained in this User's Guide. Never attempt to disassemble or modify the projector. Refer

all repairs to qualified service personnel.

• Use the type of power source indicated on the projector. Use of a different power source may result in fire or electric shock. If you are not sure of the

power available, consult your dealer or power company.

• If you use the projector in the country where it was purchased, only use the power cable that came with the projector. If you use the projector in a country

other than where you purchased it, use the correct power cord for that country.

• Do not overload wall outlets, extension cords, or power strips. Do not insert the plug into a dusty outlet. This can cause fire or electric shock.

213

Table of Contents