• Do not place the projector on an unstable cart, stand, or table. When projecting images vertically, install the projector correctly and appropriately to

prevent it from turning over and falling.

• Do not operate the projector on its side, while tilted to one side, or upside down. Do not tilt the projector forward or back at a greater angle than that

specified for vertical keystone correction. s

• If the projector is mounted on a ceiling, it should be installed by qualified technicians using mounting hardware designed for use with this projector.

Also, when mounting the projector on the ceiling, make sure to pass a wire through the handles to prevent it from falling.

• If you use a ceiling mount and apply adhesives to the mount to prevent the screws from loosening, or if you use lubricants or oils on the projector, the

projector case may crack and the projector may fall from its ceiling mount. This could cause serious injury to anyone under the mount and could damage

the projector. When installing or adjusting a ceiling mount, do not use adhesives to prevent the screws from loosening and do not use oils or lubricants.

• Do not stand on the projector or place heavy objects on it.

• Do not use the projector where it may be exposed to rain, water, or excessive humidity.

• Unplug the projector from the wall outlet before cleaning. Use a dry cloth (or, for stubborn dirt or stains, a moist cloth that has been wrung dry) for

cleaning. Do not use liquid, aerosol cleaners, or solvents such as alcohol, thinner or benzine.

• Do not use any spray containing a flammable gas to remove dirt or dust that is adhering to parts such as the lens or filter of the projector.

• Contact your dealer to clean the interior of the projector. If the interior of the projector has not been cleaned for a long time, dust may build up, which

could cause fire or electric shock.

• Never spill liquid of any kind into the projector.

• Do not use the projector where it may be exposed to excessive dust or smoke.

• Do not use the projector where it may be exposed to flammable, corrosive, or explosive gases. Because the lamp inside the projector becomes very hot

during use, the gases may ignite and result in a fire.

• Never push objects of any kind through the cabinet slots or openings.

• Do not use or store the projector or remote control in a hot location, such as near a heater, in direct sunlight, or in a closed vehicle.

• Incorrect battery usage may cause leakage of battery fluid and battery rupture, which could result in fire, injury or corrosion of the projector. When

replacing batteries, take the following precautions: Insert batteries so that the polarities (+ and -) are correct, do not use batteries of different types, do

not mix old and new batteries, and do not use any batteries other than those specified in this User's Guide. Replace the batteries as soon as they run out

and remove the batteries if you will not be using the projector for a long period of time. Do not expose batteries to heat or flame and do not put them in

water. Dispose of used batteries according to local regulations. Keep these batteries out of the reach of children. Batteries are choking hazards and are

very dangerous if swallowed. If the batteries leak, wipe away battery fluid with a soft cloth. If battery fluid gets on your hands, wash them immediately.

p.166

212

Table of Contents