Confidential
Drawer Kick-out Connector
The signal specified by the ESC p command is output to this connector. The host can check the
status of input signal by the following commands.
•
DLE EOT
•
GS r
•
GS a (ASB)
Drawer Kick-out Specifications
Item
Pin assignment
Model
Drawer kick drive signal
Drawer open/close signal
Connector appearance
Limitations
The resistance of the drawer kick-out solenoid must not be less than that specified (24 ).
Otherwisee, an overcurrent could damage the solenoid.
Drawer kick-out cable must be shielded.
Appendix A-8 Specifications
Specifications
See "Drawer kick-out connector pin assignment"
table
Printer side
Molex 52018-6615 (or equivalent)
User side
6-position 6-contact (RJ12 telephone jack)
Output voltage
Approx. 24 V
Output current
1A or less
Output waveform
Outputs the waveforms in the figure "Drawer
circuitry". (The ESC p command specifies ON
time t1 and OFF time t2.)
Input signal level
"L"= 0 V
(connector pin )
"H"= 2 Å` 5 V
t1 2 ms
t2 2 ms
1
6