Confidential
Changing the Orientation of Near End Sensor
Perform the following procedures to change the orientation of the near end sensor.
1. Place the printer horizontally and open the roll paper cover.
2. Use a coin to loosen the near end adjustment screw.
3. Turn the protrusion on the near end holder to change the position of the near end lever.
4. Tighten the near end adjustment screw, check that the near end sensor lever operates
normally and close roll paper cover.
near end sensor
holder protrusion
near end sensor
adjustment screw
near end sensor lever
1-8 Installation
Changing the orientation of Near end sensor
Roll paper cover