Epson TM-U230 Developer's Manual page 23

Confidential
Attaching the hangers
Note:
There are holes for 4 screws in the hangers (The number of the type of screw to be used is
stamped on the hanger). Use the correct screw holes.
In attaching the hangers to the printer, use the 4 screws supplied with the WH-10 wall
mounting bracket.
1. Place the hangers on the printer (one at the center and the other at the bottom of the printer).
2. Use the screw holes in the printer marked "2" for the top hanger. Secure the hanger using
two of the supplied screws.
3. Use the screw holes in the printer marked "1" for the bottom hanger. Secure the hanger using
two of the supplied screws.
Hanger
The two screw holes
labeled "1"
CAUTION:
Make sure that all 4 screws are properly secured.
Attaching the hanger
TM-U230 Developer's Guide
The two screw holes
labeled "2"
Hanger
Installation 1-15