Paper Specifications; Autocutter Specifications - Epson TM-U230 Developer's Manual

Confidential
[cpl: characters per line]
[lps: lines per second]
Note:
The dot spacing between characters for 3-half dot and 2 half-dot can be set by changing the DIP
switch setting.
0.353
2.4.

Paper Specifications

Item
Paper feed method
Paper feed interval
Paper feed speed
Paper dimensions

Autocutter Specifications

Partial cut is executed by command.
Partial cut: cutting with one point left uncut
Appendix A-2 Specifications
1.24 1.587
0.159
Figure A-1 7
Specification
Friction feed
Initial setting: approximately 0.176 mm {1/6"}
Can be set in units of approximately 0.176 mm {1/144"} by a command
Approximately 4.17 inches/second (25 lps) (continuous printing)
(lps: lines per second)
Paper roll Width: 76 ± 0.5 {3" ± 0.02"}
Maximum diameter: 83 mm
Core: when there is no near end sensor, always be sure to use a
paper roll htat is not glued to the core
Normal paper:
Paper thickness: 1 sheet 0.06 to 0.085 mm
Mass: 52.3 to 64 g/m
1091 788 mm}
9 font
2
{14 to 17lb} (45 to 55 kg/1000 sheets/
3.1
[Units: mm]