Table of Contents
Advertisement
The following accessories can be added to your unit at anytime after purchase; however, let the
unit cool down before adding any accessories.
An external thermostat (such as our Part # PU‐DTSTAT (wall) or Part # AC‐3003 (remote)) can be used on
our Pellet/Corn/Multi‐fuel units as long as it is a low‐voltage that works with millivolt systems. After
unplugging the unit, locate the "jumper" wire (J‐18) on the bottom of the control board. The two screws
should then be loosened and the jumper wire removed from the board. Next, the two thermostat lead wires
should be slipped into these openings and the screws tightened; the jumper wire should be saved for future
operation without a thermostat.
THERMOSTAT OPERATION: This stove is equipped with a unique, new feature that allows two options for
thermostatic operation: The stove comes from the factory pre‐programmed in "On/Off mode," which turns
the stove on and off when the call for heat comes or leaves, like a furnace. The second, or "High/Low mode,"
burns at whichever heat range you set the stove at until the call for heat leaves, at which point the stove goes
to the Low heat range setting.
To set the stove in the "High/Low mode," unplug the unit and plug it back in, then press and release both
down arrows; H L appears in the heat range and blower speed windows. The unit is now in "High/Low
mode." (Note: Repeat this to change back to "On/Off mode;" a 0 0 will appear in the heat range and blower
speed windows). Using a thermostat in On/Off mode may shorten the life of your stove's igniter.
Please note: Certain units may not respond to this; if your unit does not respond in this manner please
contact Technical Support at (800) 245‐6489.
There is one piece of J-Channel trim that snaps onto the ash apron. Remove the protective
covering from the trim and force the piece onto the edge. Although it should stay in place, stove
cement can be used to secure it if necessary.
PART NUMBER
PU-OAK
AC-33000
AC-33100
PU-DTSTAT
AC-3003
AC-109
AC-109BN
AC-MBSP
Replacement Parts, Accessories and Options can be ordered from the factory at:
(Parts orders ONLY) -- (800) 516-3636, or on our web site:
If you have any questions or problems contact the Technical Support Department:
Technical Support Department
P.O. Box 206
Monroe, VA 24574
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE
TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
ACCESSORY ITEMS
Thermostat
AC-109, AC-109BN Lip Trim
ACCESSORIES AND OPTIONS
PART DESCRIPTION
Outside Air Kit (Now included with unit!)
3" Corn Vent Kit (Through-the-Wall)
4" Corn Vent Kit (Through-the-Wall)
Wall Thermostat
Remote Thermostat
Brass Lip Trim
Brushed Nickel Lip Trim
High Temp. Spray Paint
service@englanderstoves.com
Parts Orders ONLY: 800-516-3636
Questions: 800-245-6489
26
www.englanderstoves.com
(Fax: 434-929-4810)
.
Advertisement
Table of Contents
