Sending A Fax While Confirming The Status Of The Recipient's Machine (Manual Transmission) - Konica Minolta bizhub C451 User Manual

To send a fax
2.11 Sending a fax while confirming the status of the recip-
ient's machine (Manual transmission)
Use this operation when sending a fax while checking the status of the re-
ceiving machine. This is called a manual transmission.
Quick Memory TX cannot be used with manual transmission.
1
Press [Fax/Scan] key to display the Fax/Scan screen.
2
Load the original to be faxed.
– Refer to "Loading the original" on page 2-7 for details on loading
the original.
3
Specify Scan Settings functions if required.
– For details on scan settings, refer to "Specifying scanning condi-
tions" on page 2-12 or "Scan Settings" on page 6-2.
4
Touch [Off-Hook].
– When [RX] is selected, touch [Send] to set the machine to Tranmis-
sion mode.
– If "Confirm Address (TX)" in Utility mode is set to "ON", [Off-Hook]
does not appear.
– When an external phone is connected, lifting the receiver of the ex-
ternal phone places the machine in the same state as that when
[Off-Hook] is touched.
5
Destinations are specified as follows.
– Specifying from registered destinations
– Specifying by direct input
– Specifying from the job history
– Specifying from the program destinations
6
Touch [Start] when you hear a repeated "paw...paw" sound.
– When [Start] key is pressed, the "Off-Hook start" confirmation
screen is displayed. Touch [Yes] and then touch [OK] to start trans-
mission.
The transmission begins.
If using an external telephone, replace the external telephone's receiv-
er.
C451
2
2-48