Messages And Error Codes; User Attendance Messages; Paper Jam Error Codes - Lexmark E250DN - Govt Laser 30PPM Special Build Mono Taa Service Manual

Messages and error codes

Note: The following message and error codes will be visible only in the print history in the diagnostic mode
for E250d and E250dn. See
The printer operator panel displays light patterns describing the current state of the printer and indicates
possible printer problems that must be resolved. This topic provides a list of all printer messages and explains
what they mean.

User attendance messages

Cartridge error codes
Error
31
32
33

Paper jam error codes

Paper jam error codes
Error
200.00
200.01
200.02
200.03
200.04
200.06
200.08
200.09
200.12
200.13
200.14
200.15
200.16
"Diagnostics mode selections" on page
Description
Defective cartridge
Unsupported cartridge
Invalid refill
Description
Paper jam around input sensor.
Classic input jam. The media is too long over the input sensor. Possible causes
include multi-sheet feed, tray size sensing problem, and media slippage.
The main input sensor never became uncovered from the sheet ahead.
The video never started on the page at the input sensor within two inches after
hitting the input sensor
The media at the input sensor before interrupt occurred - not enough time elapsed
since the printhead started to expect the printhead mirror motor lock. Possible
causes include bouncy sensor or exceptionally fast pick - perhaps due to media
pre-staged in the source tray.
Imaged page not expected page (bouncy passthru sensor)
Media reached the input sensor before the EP was ready
Transfer servo never started
Media detected at manual feeder sensor when not expected. Possible causes
include user insert of media when motor is running or pre-staged media in the tray.
The input sensor is covered when the media is not expected (media in machine
during warm-up)
Trailing edge cleared manual feed, but did not successfully debounce the sensor.
Potential causes are a small gap or a bouncy manual feed sensor.
UNRECOVERABLE NO GAP JAM. Engine detected no gap at the manual feeder
sensor, attempted to open the gap by stopping the feed rolls, but no trailing edge
was ever seen at the input sensor.
Transport motor error detected
4512-220, -230
3-8.
Diagnostic information
2-29