Lexmark E250DN - Govt Laser 30PPM Special Build Mono Taa Service Manual page 98

4512-220, -230
Rear cover removal
1.
Remove the right side cover. See
2.
Remove the left side cover. See
3.
Remove the two screws (A).
4.
Open the rear cover.
5.
Lift the rear cover, unhooking it from the frame at the bottom, and remove.
Note: In re-installation, check to make sure that the fuser ground cable is routed out of the way and is not
pinched or damaged.
4-6
Lexmark™ E250d and E250dn
"Right side cover removal" on page
"Left side cover removal" on page
4-5.
4-4.