Emerson Oxymitter 4000 Instruction Manual page 3

Page
Cover
P-3 through P-14
P-22
1-1
1-2
1-3
1-4
1-6
1-7
1-14, 1-15
1-16, 1-17
2-1
2-4
2-9
2-12
3-1
3-2
3-3
3-5, 3-6
4-1 through 4-6
5-1
6-1 through 6-6
8-1
8-3
8-4
HIGHLIGHTS OF CHANGES
Effective December, 2003 Rev. 3.0
Summary
Updated photo, revision number, and date.
Added foreign language versions of 'Safety Instructions for the Wiring
and Installation of this Apparatus'.
Revised Figure 1 to include remote electronics versions.
Revised para. 1-2a to include Local operator Interface (LOI) and Model
375 communicator. All IB references to HART Model 275 changed to
read 'HART Model 275/375'.
Revised Figure 1-1 to include Oxymitter 4000 with remote electronics.
Revised para. 1-2c to include reference to remote electronics version.
Revised para. 1-2d to include differences between units with LOI versus
membrane keypad and to include new Figure 1-3 and Figure 1-4 views.
Revised NOTE to include LOI operating temperature data.
Revised Figure 1-7 to include remote electronics versions.
Revised para. 1-7 Specifications to include LOI data, update electronic
noise data, temperature range data, and certification references.
Revised Table 1-1 Product Matrix to update Communication Options and
Calibration Accessories, and to include Probe-to-Electronics Cables.
Revised para. 2-1a to reference remote electronics version and LOI.
Revised Figure 2-3 to indicate the integral electronics version is shown.
Added para. 2-1c to discuss mounting of remote electronics version.
Added new para. 2-3 for installing remote electronics version.
Revised section heading to denote configuration instructions applicable
to membrane keypad version only.
Revised para. 3-1e.4 to define new voltage selection parameters.
Revised Figure 3-2 to update default parameter settings.
Revised para. 3-3a to correct mA signal level values. Moved power up
procedure to Section 5.
Added new Section 4 to discuss unit configuration with the LOI. Previous
Section 4 is now Section 5.
Revised section heading to apply to membrane keypad version only.
Added new Section 6 to discuss Operation with the LOI. Previous
Sections 5 through 11 are now Sections 7 through 13.
Added new Figure 8-1 and related overview discussion.
Revised para. 8-5 to include reference to LOI error indications.
Corrected mA signal level values in notes for Table 8-1. Added Table 8-2
to identify to LOI fault/alarm messages.