Figure 2-15. Jumper Selection Label; Figure 2-16. Jumpers On Hps Mother Board - Emerson World Class 3000 Instruction Manual

Instruction Manual
IB-106-300NH Rev. 4.3
May 2005
LINE VOLTAGE
SELECTION
100/120 VAC
1
220/240 VAC
PROBE HEATER
2
VOLTAGE SELECTION
WORLD CLASS PROBE
218 PROBE (115V)
Before supplying power to the heater
power supply, verify that jumpers JM3,
JM6 are removed and JM7 is installed.
If relay wire (Figure 2-13, note 1) is in-
stalled, JM2 must be removed from
HPS Mother Board (Figure 2-16).
4. Before supplying power to the heater
power supply, verify that the jumpers
on the mother board, Figure 2-16, are
properly configured. Jumpers JM3 and
JM6 should be removed and JM7
should be installed.
Additionally, make sure that the proper
jumper for your line voltage is installed,
Figure 2-15. If relay wire (Figure 2-13,
note 1) is not installed, JM 2 should be
installed on the HPS Mother Board
(Figure 2-16).
Refer to Figure 2-8 and Figure 2-10 for
proper IFT jumper configuration. IFT
microprocessor and interconnect
board jumper configurations must be
set correctly in order for HPS to work
properly.
2-20 Installation
JUMPER
(INSTALL)
JM4, JM1
JM5
JUMPER
(INSTALL)
JM7
(44V)
JM8
NOTES:
1
100 VAC OPERATION REQUIRES TRANSFORMER PART
NUMBER 1M02961G02.
2
REFER TO TABLE 3-5 FOR PROPER SET POINT SELECTION.

Figure 2-15. Jumper Selection Label

NOTE
NOTE
ALWAYS DISCONNECT LINE VOLTAGE
FROM HEATER POWER SUPPLY AND
JUMPER ANALOG ELECTRONICS (IF USED)
BEFORE CHANGING JUMPERS.
CONFIGURATIONS
HEATER
POWER
REMOTE
ON
ELECTRONICS
SELECTION
*ANALOG (EXISTING)
DIGITAL
(NEXT GENERATION)
FUSES
JM1
JM2
JM4
JM7
FUSE
NOTE: ALL FUSES ARE 5A @ 250 VAC,
ANTI-SURGE, CASE SIZE
5 X 20 MM, TYPE T TO IEC127,
SCHURTER.

Figure 2-16. Jumpers on HPS Mother Board

Rosemount Analytical Inc.
World Class 3000
JUMPER
REMOVE JM2
*INSTALL JM2
JUMPER
INSTALL JM3, JM6
REMOVE JM3, JM6
37840009
JM5
A Division of Emerson Process Management
29850001