Table of Contents
Advertisement
11) The device shall drive the first word of the data transfer onto DD (15:0). This step may
occur when the device first drives DD (15:0) in step (10).
12) To transfer the first word of data the device shall negate DSTROBE within t
host has negated STOP and asserted HDMARDY-. The device shall negate DSTROBE no
sooner than t
5.5.3.2 The data in transfer
The following steps shall occur in the order they are listed unless otherwise specifically
allowed (see 5.6.4.3 and 5.6.4.2):
1) The device shall drive a data word onto DD (15:0).
2) The device shall generate a DSTROBE edge to latch the new word no sooner than t
after changing the state of DD (15:0). The device shall generate a DSTROBE edge no
more frequently than t
generate two rising or two falling DSTROBE edges more frequently than 2t
selected Ultra DMA mode.
3) The device shall not change the state of DD (15:0) until at least t
DSTROBE edge to latch the data.
4) The device shall repeat steps (1), (2) and (3) until the data transfer is complete or an Ultra
DMA burst is paused, whichever occurs first.
5.5.3.3 Pausing an Ultra DMA data in burst
The following steps shall occur in the order they are listed unless otherwise specifically
allowed (see 5.6.4.4 and 5.6.4.2 for specific timing requirements).
a) Device pausing an Ultra DMA data in burst
1)
The device shall not pause an Ultra DMA burst until at least one data word of an Ultra
DMA burst has been transferred.
2)
The device shall pause an Ultra DMA burst by not generating DSTROBE edges.
NOTE - The host shall not immediately assert STOP to initiate Ultra DMA burst
termination when the device stops generating STROBE edges. If the device does not
negate DMARQ, in order to initiate ULTRA DMA burst termination, the host shall
negate HDMARDY- and wait t
3)
The device shall resume an Ultra DMA burst by generating a DSTROBE edge.
b) Host pausing an Ultra DMA data in burst
1)
The host shall not pause an Ultra DMA burst until at least one data word of an Ultra
DMA burst has been transferred.
2)
The host shall pause an Ultra DMA burst by negating HDMARDY-.
after driving the first word of data onto DD (15:0).
DVS
for the selected Ultra DMA Mode.
CYC
RP
C141-E055-01EN
before asserting STOP.
after the
FS
DVS
The device shall not
for the
CYC
after generating a
DVH
5 - 65
Hide quick links:
Advertisement
Table of Contents
