Fujitsu MPC3096AT - Desktop 9.7 GB Hard Drive Product Manual page 117

(29) FLUSH CACHE (X 'E7')
This command is use by the host to request the device to flush the write cache. If the write
cache is to be flushed, all data cached shall be written to the media. The BSY bit shall remain
set to one until all data has been successfully written or an error occurs. The device should
use all error recovery methods available to ensure the data is written successfully. The
flushing of write cache may take several seconds to complete depending upon the amount of
data to be flushed and the success of the operation.
NOTE - This command may take longer than 30 s to complete.
If the command is not supported, the device shall set the ABRT bit to one. An unrecoverable
error encountered during execution of writing data results in the termination of the command
and the Command Block registers contain the sector address of the sector where the first
unrecoverable error occurred. The sector is removed from the cache. Subsequent FLUSH
CACHE commands continue the process of flushing the cache.
At command issuance (I/O registers setting contents)
1F7 (CM)
H
1F6 (DH)
H
1F5 (CH)
H
1F4 (CL)
H
1F3 (SN)
H
1F2 (SC)
H
1F1 (FR)
H
At command completion (I/O registers contents to be read)
1F7 (ST)
H
1F6 (DH)
H
1F5 (CH)
H
1F4 (CL)
H
1F3 (SN)
H
1F2 (SC)
H
1F1 (ER)
H
5 - 54
X'E7'
DV xx
xx
xx
xx
xx
xx
Status information
DV xx
xx
xx
xx
xx
Error information
C141-E055-01EN