Spindle; Actuator; Air Filter - Fujitsu MPC3096AT - Desktop 9.7 GB Hard Drive Product Manual

4.2.3

Spindle

The spindle consists of a disk stack assembly and spindle motor. The disk stack assembly is
activated by the direct drive sensor-less DC spindle motor, which has a speed of 5,400 rpm
±0.5%. The spindle is controlled with detecting a PHASE signal generated by counter
electromotive voltage of the spindle motor at starting. After that, the rotational speed is kept
with detecting a servo information.
4.2.4

Actuator

The actuator consists of a voice coil motor (VCM) and a head carriage. The VCM moves the
head carriage along the inner or outer edge of the disk.
controlled by feeding back the difference of the target position that is detected and reproduced
from the servo information read by the read/write head.
4.2.5

Air filter

There are two types of air filters: a breather filter and a circulation filter.
The breather filter makes an air in and out of the DE to prevent unnecessary pressure around
the spindle when the disk starts or stops rotating. When disk drives are transported under
conditions where the air pressure changes a lot, filtered air is circulated in the DE.
The circulation filter cleans out dust and dirt from inside the DE. The disk drive cycles air
continuously through the circulation filter through an enclosed loop air cycle system operated
by a blower on the rotating disk.
C141-E055-01EN
The head carriage position is
4 - 3