Storage - Delta DT2400CS Instruction Manual

ENGINE
Consult the Engine Owners Manual for the manufacturer's recommendations for

storage.

PUMP
1. Drain all water from high pressure hose, coil it, and store it in cradle of the
pressure washer handle.
2. Drain all water from spray gun and spray wand by holding spray gun in a
vertical position with nozzle end pointing down and squeezing trigger. Store
in gun/hose holder.
3. Store chemical injector rinsing hose, high pressure hose, spray gun, and
spray wand so they are protected from damage, such as being run over.
It is recommended that you follow these steps to protect the internal seals of the
pressure washer when STORING THE UNIT FOR MORE THAN 30 DAYS AND/OR
WHEN FREEZING TEMPERATURES ARE EXPECTED.
*RV antifreeze needs to be run through the pump as outlined in the steps below.
4. Obtain a funnel, six ounces of *RV
antifreeze, and approximately 36
inches of garden hose with a male
hose connector attached to one end.
corrosive and can damage pump.
5. Disconnect spark plug wire.
6. Connect 36 inch length of hose to
water inlet of pump.
7. Add *RV antifreeze to hose as shown.
8. Pull engine starter rope slowly several times until antifreeze comes out of
high pressure hose connection of pump.
9. Remove short hose from water inlet of pump.
10. Reconnect spark plug wire.
*Windshield washer fluid may also be used
Use only RV antifreeze.
Any other antifreeze is
STORAGE
19- ENG
D27918