ZyXEL Communications Prestige 2802HW(L)-IX Support Notes page 83

•
EAP-Packet : Both the supplicant and the authenticator send this packet when authentication is
taking place. This is the packet that contains either the MD5-Challenge or TLS information
required for authentication.
•
EAPOL-Start : This supplicant sends this packet when it wants to initiate the authentication
process.
•
EAPOL-Logoff : The supplicant sends this packet when it wants to terminate its 802.1x session.
•
EAPOL-Key : This is used for TLS authentication method. The Wireless AP uses this packet to
send the calculated WEP key to the supplicant after TLS negotiation has completed between the
supplicant and the RADIUS server.
IEEE 802.1x Configuration in ZyXEL Wireless Access Point
•
Enable 802.1x in AP
When the IEEE 802.1x authentication is enabled, the wireless client must be authenticated by the ZyXEL AP
before it can communicate on your network through ZyXEL AP. By default, the 802.1x function is disabled
(Authentication Control= Force Authorized) to allow all wireless client. You can use Web Configuration to
configure it.
All contents copyright (c) 2007 ZyXEL Communications Corporation.
Prestige 2802HW(L)-Ix Support Notes
83