ZyXEL Communications Prestige 2802HW(L)-IX Support Notes page 24

2. Address Mapping Sets and NAT Server Sets
Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global addresses
to LAN clients. Each remote node must specify which NAT Address Mapping Set to use. The P2802HWL has
8 remote nodes and so allows you to configure 8 NAT Address Mapping Set. You can see nine NAT Address
Mapping sets in WEB GUI
Set 10 when you select Full Feature in WEB GUI NAT configuration. When you select SUA Only, the
Forwarding
will auto configure as to Many to one and Server as default in system.
The NAT Server Set is a list of LAN side servers mapped to external ports. To use this set (one set for the
Prestige), a server rule must be set up inside the NAT Address Mapping set. Please see
further information on these menus.
Network > NAT > Address Mapping
Enter WEB GUI
Now let's look at WEB GUI Menu
Network > NAT > Address Mapping
Network > NAT > Address Mapping
All contents copyright (c) 2007 ZyXEL Communications Corporation.
Prestige 2802HW(L)-Ix Support Notes
pre-configured, read only, Many-to-One mapping set,
sufficient for most purposes and helpful to people
already familiar with SUA in previous ZyNOS
versions. Note that there is also a Server type whose
IGA is 0.0.0.0 in this set.
to bring up Address Mapping Sets Menu.
. You can only configure from Set 1 to
NAT Server Sets
.
Port
for
24