Configuring A Filter Rule; Tcp/Ip Filter Rule; Table 7-2 Abbreviations Used If Filter Type Is Ip; Table 7-3 Abbreviations Used If Filter Type Is Gen - ZyXEL Communications Prestige 314 User Manual

If the filter type is IP, the following abbreviations listed in the following table will be used.
Table 7-2
Abbreviation
Pr
SA
SP
DA
DP
If the filter type is GEN (generic), the following abbreviations listed in the following table will be used.
Table 7-3
Abbreviation
Off
Len
Refer to the next section for information on configuring the filter rules.

7.2.2 Configuring a Filter Rule

To configure a filter rule, type its number in Menu 21.1 – Filter Rules Summary and press [ENTER] to
open Menu 21.1.1 for the rule.
To speed up filtering, all rules in a filter set must be of the same class, i.e., protocol filters or generic filters.
The class of a filter set is determined by the first rule that you create. When applying the filter sets to a port,
separate menu fields are provided for protocol and device filter sets. If you include a protocol filter set in a
device filter field or vice versa, the Prestige will warn you and will not allow you to save.

7.2.3 TCP/IP Filter Rule

This section shows you how to configure a TCP/IP filter rule. TCP/IP rules allow you to base the rule on the
fields in the IP and the upper layer protocol, e.g., UDP and TCP, headers.
To configure a TCP/IP rule, select TCP/IP Filter Rule from the Filter Type field and press [ENTER] to open
Menu 21.1.1 – TCP/IP Filter Rule, as shown below.
Filter Configuration
P314 Broadband Sharing Gateway with 4-Port Switch
Abbreviations Used If Filter Type Is IP
Description
Protocol
Source Address
Source Port number
Destination Address
Destination Port number
Abbreviations Used If Filter Type Is GEN
Description
Offset
Length
7-7