Sony PMW-100 Operating Instructions Manual page 98

OTHERS
Menu items Subitems and setting values Contents
Tally
Front
Setting the tally
lamps
Hours Meter
Hours (Sys)
Displaying the
Hours (Reset)
hours meter
Reset
IR Remote
Activating/
deactivating the
Remote
Commander
Battery Alarm
Low BATT
Setting the low
power alarm
BATT Empty
DC Low Volt1
DC Low Volt2
Battery INFO
Type
Showing
MFG Date
information
Charge Count
regarding the
battery pack
Capacity
(display only)
Voltage
Remaining
Genlock H Phase (HD)
Setting Genlock
operation
H Phase (SD)
Direct Menu
Setting the Direct
menu function
Trigger Mode
Setting for
operating an
external recording
device connected
via the i.LINK
connector (FAT
only)
[M]
98 Setup Menu List
High / Low / Off
Execute/Cancel
On / Off
5% / 10% / 15% / ... / 45% /
50%
3% to 7% (3%)
11.5 V to 17.0 V (11.5 V)
11.0 V to 14.0 V (11.0 V)
–999 to +999 (±0)
–99 to +99 (±0)
All / Part / Off
Internal / Both / External
Steady Shot: For turning the Steady Shot function on/off.
Set the brightness of the tally lamp.
High: To brighten the lamp
Low: To dim the lamp
Off: To not light the lamp
The non-resettable accumulated time of use is displayed.
The resettable accumulated time of use is displayed.
Select "Execute" to reset the Hours (Reset) value to 0.
Set to "On" to activate remote control operations from the
supplied IR Remote Commander.
Note
The setting automatically returns to "Off" when the
camcorder is turned off.
Set the battery level at which the Low BATT warning is
generated (in steps of 5%).
Set the battery level at which the BATT Empty warning is
generated.
Set the DC IN voltage at which the DC Low Volt1 warning is
generated.
Set the DC IN voltage at which the DC Low Volt2 warning is
generated.
The type (product name) is displayed.
The date of manufacture is displayed.
The accumulated number of times of charge/discharge is
displayed.
The estimated total capacity of full charge is displayed.
The current output voltage is displayed.
The current remaining level is displayed.
Set the H phase (phase of the horizontal sync signal) of HD
signal for Genlock operation.
Set the H phase (phase of the horizontal sync signal) of SD
signal for Genlock operation.
All: All Direct menu operations are permitted.
Part: A part of Direct menu operations is permitted. The
operation is limited depending on the GAIN, SHUTTER,
or WHITE BAL switch setting.
Off: No Direct menu operation is permitted.
Internal: To activate recording start/stop operations only for
an SxS memory card in a built-in slot.
Both: To activate recording start/stop operations both for an
SxS memory card in a built-in slot and the external
recording device connected via the i.LINK connector.
External: To activate recording start/stop operations only for
the external recording device connected via the i.LINK
connector.