Sony PMW-100 Operating Instructions Manual page 103

OTHERS
Menu items Subitems and setting values Contents
MAC Address
Net Config Reset
Execute / Cancel
Wi-Fi Scan Networks
Execute / Cancel
(PMW-200 only)
Setting for Wi-Fi
SSID (Network connection name
connection
display)
Reset
Note
Network Type
The CBK-WA01
Infra / Adhoc
Wi-Fi Adapter is
required.
Ch
1 to 11
Authentication
When "Network Type" is "Infra"
Open / Shared / WPA / WPA2
When "Network Type" is "Adhoc"
Open / Shared
Encryption
When "Authentication" is "Open"
or "Shared"
Disable / WEP
When "Authentication" is "WPA"
or "WPA2"
Disable / TKIP / AES
WEP Key Index
1 / 2 / 3 / 4
Input Select
When "Encryption" is "WEP"
ASCII5 / ASCII13 / HEX10 /
HEX26
When "Encryption" is "TKIP" or
"AES"
ASCII8-63 / HEX64
Key (network key)
Set
Execute / Cancel
Wi-Fi Status
x x x Connecting (display
only)
Wireless Mode
802.11b / 802.11g / 802.11n
Wi-Fi
Enable / Disable
Wi-Fi Remote
On / Off
Display the MAC address.
Reset the "Network" settings to the preset values.
Select "Execute" to reset.
Scan the available network connections when "Wi-Fi" is set
to "Enable."
Reset the network connection name to the default settings.
Select the connection mode.
Infra: Infrastructure mode
Adhoc: Ad hoc mode
Set the wireless channel when "Network Type" is "Adhoc."
Select the network authentication.
Open: Open system authentication
Shared: Shared key authentication
WPA: WPA (Wi-Fi Protected Access) authentication
WPA2: WPA2 (Wi-Fi Protected Access 2) authentication
Select the type of data encryption.
Disable: Do not apply data encryption.
WEP: Apply WEP (Wired Equivalent Privacy)
TKIP: Apply TKIP (Temporal Key Integrity Protocol)
AES: Apply AES (Advanced Encryption Standard)
Select the key index when "Encryption" is "WEP."
Select the input format depending on the network key (or
security key).
ASCII5: Five characters ASCII format
ASCII13: 13 characters ASCII format
HEX10: 10 hexadecimal digits
HEX26: 26 hexadecimal digits
ASCII8-63: 8 to 63 characters ASCII 8-bit format
HEX64: 64 hexadecimal digits (characters)
Set the network key (or security key).
Confirm the "Wi-Fi" settings when "Wi-Fi" is set to "Enable."
Select "Execute" to confirm.
Display "Connecting" while connection is being attempted.
Display black squares to show the connection status by the
number of squares during communication.
Display an IEEE802.11 standard.
Select whether to enable or disable Wi-Fi connection.
Select "On" when using the Wi-Fi remote commander.
Note
Unselectable when "Wi-Fi" is set to "Disable."
Setup Menu List 103