Sony PMW-100 Operating Instructions Manual page 56

PICTURE PROFILE SET
Items
Color Correction
(PMW-200 only)
Adjusting the color phase in
a specific area (Unselectable
when "Multi Matrix" is
selected in the Multi Matrix
mode)
White
Setting the white balance
offset and the color
temperature of the preset
white
56 Useful Functions
Subitems and setting values Contents
Setting
On / Off
2)
Area Detection
Execute/Cancel
1)
Area Indication
On / Off
Target Phase
0 to 359 (130)
Target Width
0 to 90 (40)
Level
–99 to +99 (±0)
Phase
–99 to +99 (±0)
Offset White
On / Off
Offset<A>
–99 to +99 (±0)
Offset<B>
–99 to +99 (±0)
Offset<ATW>
–99 to +99 (±0)
Preset White
2100 to 10000 (3200)
Set to "On" to enable the color phase adjustment
for a specific area. (Simultaneous adjustment of
multiple areas is not allowed. You can adjust it for
one area only.)
Execute to detect the color in the center of the
screen. The area centering around the detected
color of the range specified by "Target Width"
becomes the target area of Color Correction.
Set to "On" to display the Zebra 1 pattern for the
area targeted for Color Correction.
Note
The area where the Zebra 1 pattern is displayed and
the area targeted for Color Correction, may differ.
Manually adjust the center color for the area
targeted for Color Correction.
Note
When Area Detection is executed, this setting is
overwritten by the Area Detection result. Perform
fine adjustment with this item as required.
Set the width of color phase for the area targeted for
Color Correction.
Set the saturation for the color in the target area.
Adjust the hue for the color in the target area.
Set to "On" to shift the conversion value for auto
white balance in Memory A or B mode and that for
auto tracing white in ATW mode to a lower color
temperature or a higher color temperature.
Adjust the volume of the offset white (shifting
volumes) of the conversion value in Memory A,
Memory B, or ATW mode, respectively.
Adjust the preset color temperature when Preset
white balance mode is selected in steps of 100K.
Notes
• Except when the white balance is in Memory A
or B mode or when ATW is active, you cannot
confirm the result of changing the Offset White
and Offset settings on the screen.
• Except when Preset white balance mode is
selected, you cannot confirm the result of
changing the Preset White settings on the screen.