Download Print this page

Adobe 22011302 Manual page 5

Product brief
Hide thumbs Also See for 22011302:

Advertisement

1. Open Audition 3.0.
2. Go to Help > Transfer Activation.
3. Follow the steps to complete the process.
4. Uninstall Audition 3.0.
Windows Vista: Installing Adobe Audition 3.0 from the MSI file results in an activation error
on launch
If you run the Adobe Audition 3.0.msi file in Windows Vista, Audition will install, but when you try to
launch, you will receive the following error:
"Current user account does not have the privileges to perform product activation.
Run this application from a user account with administrative privileges or contact
your system administrator."
To fix this issue, either:
1. Run the Audition 3.0 Setup.exe file to install instead of running the .msi file.
2. If you have already installed, repair the installation from the Uninstall command in the
Windows Control Panel.
Windows Vista: AERO: "Enable Desktop Composition" causes dropouts during recording.
Due to increased video and CPU processing used by the Windows Vista "AERO" feature,
recording while this is enabled may produce some dropouts, especially with computers that are
close to the minimum system requirements, recording at higher sample rates and bit depths,
and/or while recording in any of the spectral viewing modes (frequency, pan, or phase).
To help remedy this, you can record using waveform view only. If you still get dropouts, you can
also disable the AERO feature called "Desktop Composition" under Windows Vista performance
options:
1. Open Control Panel.
2. Double-click "System."
3. Click "Advanced System Settings."
4. Under visual Effects, un-check the box next to "Enable Desktop composition."
5. Click Apply, and then click OK.
Enabling Live Preview of MIDI Sequencer:
In order to preview VSTi audio and MIDI Input while idle, users must perform two steps:
1. MIDI Tracks must be set to "Live Monitoring" mode by clicking the green "L" button located
in the track controls panel in Multitrack. It is in the same location as the "Record Enable"
button is located on Audio tracks.
2. Set Monitoring Mode, located in the Session Properties panel, to "Audition Mix." This
enables the internal Audition mixing engine to process VSTi output without the need to be
in a record or playback state.
Adobe Bridge CS3 cannot be installed from a network location
Adobe Bridge CS3 is included with Adobe Audition 3.0 and can be installed in the following ways:

Advertisement

loading

This manual is also suitable for:

Audition 3.0