Installing The Batteries - Emerson Research iP500 Owner's Manual

Installing The Batteries

The battery compartment is located on the back cabinet. We recommend that you
place the unit on a soft surface such as a carpet, on a towel or blanket before
turning the unit face down to install the batteries. This will prevent any scratches
on the cabinet finish.
1.) With the unit face down press both
battery cover locking tabs in the
direction of the arrow marks and
remove the battery compartment cover.
2.) Insert 8 "AA" batteries, not included, in
the battery compartment according to the
polarity markings engraved in the
compartment. If the batteries are inserted
incorrectly the unit will not work.
NOTE: We recommend that you use a
well-known brand of alkaline batteries
for longest life and best performance.
3.) Replace the battery compartment and make sure that it locks securely in place.
IMPORTANT: In order to operate the unit on batteries the AC adapter must
be disconnected from the DC IN 10V jack on the back cabinet.
iP500_042307.p65
6
6 23/4/2007, 17:00