Setting The Time - Emerson Research iP500 Owner's Manual

OPERATING INSTRUCTIONS
• Make sure that you have installed the 8 "AA" batteries or have connected
the unit to your household AC outlet with the supplied AC adapter.
• Make sure that you have removed the clear plastic battery spacer tab
from the remote control.
• Make sure that you have unwound the FM antenna wire and extended it
to its full length.

Setting The Time

The first time you connect this system to your AC outlet the display will turn on and
show AM "12:00" and "1/ 1" (January 1
The colon will begin to flash indicating that the clock
is running.
1.) Press the Mode button 3 times. The time display
will begin to flash.
2.) Press the Tuning + (
buttons on the remote control to set the Hour display forward or backward to
the correct hour.
Example: PM 2:00.
Be sure to observe the PM indicator to confirm that you have set the hour
correctly. If no PM indicator appears the time display is AM.
3.) Press the Volume + or Volume – buttons to set the Minute display forward or
backward to the correct minute.
Example: PM 2:45.
4.) Within 10 seconds after you adjust the time the display will stop flashing and
the clock begins to run.
NOTE: If the display stops flashing before you finish setting the correct
time, your setting will not be completed. If this occurs, repeat steps 1 through 3
and be sure to complete your settings while the display is still flashing.
iP500_042307.p65
st
).
) / – ( ) buttons on the top panel or TUN
17
17
/
23/4/2007, 17:00