Remote Control - Emerson Research iP500 Owner's Manual

Remote Control

The remote control supplied with this system allows you to operate all of the features
and functions found on the main unit control panel. The remote receiver is located
in the upper right corner of the front panel. To operate the remote control, aim the
handset at the receiver on the front panel and press the appropriate button on the
remote handset.
The effective operating distance of the remote control is approximately 15 feet
from the remote receiver on the front panel.
®
IMPORTANT! Please note that the iPod Shuffle has no interface to accept
commands from a remote control. The remote control of this system will not
®
operate an iPod Shuffle. You must use the controls on the Shuffle itself to
®
operate an iPod Shuffle.
Remote Control Battery
The remote control operates on one 3V lithium ' button' battery, Type CR2032 or
equivalent. The battery was installed in the remote when you purchased this system.
To preserve the life of the battery a small clear plastic
spacer tab is installed between the battery and the battery
terminal. This tab must be removed before the remote
control can be used.
To remove the tab simply pull it out of the battery
compartment, as shown, and discard it.
10
iP500_042307.p65 10 23/4/2007, 17:00