Snooze Operation - Emerson Research iP500 Owner's Manual

Wake-up To Buzzer With Auto Snooze Function
1.) Check and adjust the alarm time setting if necessary and make sure the
"BUZ " alarm mode is selected.
2.) Press the Alarm On/Off button to activate the alarm. Make sure the "BUZ
icon appears in the display.
3.) At the selected wake up time the Buzzer will turn on automatically.
It continues for 1 minute and then enters the
"Auto Snooze" mode.
After one minute the buzzer will shut off for 9-10
minutes and then turn on again automatically.
This "Buzzer/Auto Snooze" cycle will be repeated three more times, but after
the fourth time the alarm will shut off and reset itself for the following day.
4.) To stop the buzzer alarm sooner, press the Alarm On/Off button once. The
buzzer stops immediately but the "BUZ
and alarm remains set for the following day. To deactivate the alarm completely,
press the Alarm On/Off button once more. The "BUZ

Snooze Operation

If you need a few minutes extra sleep when the Radio or iPod alarm turns on in the
morning, press the Snooze/Light button. The alarm will stop for 9-10 minutes and
then turn on again. The Snooze operation may be repeated 3 times but after the
4th time the alarm will not repeat. It will shut off and reset itself for the following
day.
The buzzer alarm automatically enters the "Auto Snooze" mode after one minute
as mentioned above. However you may still use the manual snooze mode for the
buzzer alarm by simply pressing the Snooze/Light button as soon as the buzzer
alarm turns on.
iP500_042307.p65
" indicator remains in the display
38
38
" indicator disappears.
23/4/2007, 17:01
"