Emerson Research iP500 Owner's Manual page 10

Reset Button (On BACK Panel)
If this system is subjected to a sudden power surge, or excessive static electricity,
the internal computer will shut down temporarily to prevent any permanent damage
to the system. If you find that the system does not respond when you operate the
controls on the top panel or the remote handset, you have probably experienced a
sudden power surge that caused the internal computer to shut down.
To correct this problem and reset the internal computer, first disconnect the AC
power cord for 60 seconds and then plug it in again.
If this still does not correct the problem, use the point of a ballpoint pen, a toothpick,
a straightened paper clip, or similar object to press the RESET button, located in a
small hole near the battery compartment door, under the door looking tab.
RESET
Pressing the RESET button will reset the system and clear the system memory.
The system should then operate normally again, however it will be necessary to
reset the clock, the alarm setting, and re-enter all of your preset stations in the
tuner memory after pressing the RESET button.
9
iP500_042307.p65 9 23/4/2007, 17:00