Advertisement
Introduction
The 1x4 3G-SDI Splitter allows you to broadcast
3G-SDI signals from one source to four outputs.
Key Features and Benefits
•
Replicates and distributes content from 1
3G-SDI source to 4 outputs
•
Operates at 270Mb/s, 1.485Gb/s and
2.97Gb/s data rates
•
Supports HD formats:
• 720p24, 25, 30, 50 & 60
• 1080i50 & 60
• 1080p24, 25, 30, 50 & 60
•
Supports 525i & 625i SD formats
•
Metal housing and wall-mountable
Package Contents
•
1x4 3G-SDI Splitter
•
Power adapter
•
Quick installation guide
04-0732A
1x4
3G-SDI
Quick Installation Guide
Splitter
1
Advertisement
Table of Contents
Related Manuals for SIIG 1x4 3G-SDI Splitter
Summary of Contents for SIIG 1x4 3G-SDI Splitter
- Page 1 3G-SDI Splitter Quick Installation Guide Introduction The 1x4 3G-SDI Splitter allows you to broadcast 3G-SDI signals from one source to four outputs. Key Features and Benefits • Replicates and distributes content from 1 3G-SDI source to 4 outputs • Operates at 270Mb/s, 1.485Gb/s and 2.97Gb/s data rates •...
- Page 2 Layout SDI IN LED indicators Power jack adapter USB port (for future firmware upgrade) SDI OUT Figure 1: Layout Hardware Installation Power off all devices you plan to connect to this splitter. Connect your SDI source to the splitter’s SDI IN connector using a SDI cable (not included).
- Page 3 Dip Switch • Re-Clock: Receives a signal and retransmits it at a higher level and /or higher power, or onto the other side of an obstruction, so the signal can cover longer distances • LB SEL0: Disabled (Not used) • LB SEL1: Disabled (Not used) Note: Pin up: Enabled (on) Pin down: Disabled (off)
- Page 4 Blank page...
- Page 5 Blank page...
- Page 6 Blank page...
- Page 7 Go to www.siig.com, click Support, then REQUEST A PRODUCT REPLACEMENT to submit a request to SIIG RMA or fax a request to 510-657-5962. Your RMA request will be processed, if the product is determined to be defective, an RMA number will be issued.
- Page 8 Fremont, CA 94538-3152, USA Phone: 510-657-8688 1x4 3G-SDI Splitter is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG, Inc. All other names used in this publication are for identification only and may be trademarks of their respective owners.
Need help?
Do you have a question about the 1x4 3G-SDI Splitter and is the answer not in the manual?
Questions and answers