Operating Your Ceiling Fan - Emerson BANFF CF720ORB00 Owner's Manual

BP7309 BANFF 1/5/06 9:59 AM
9. Position the downlight fitter assembly
on the light fitter adapter plate so that
the two screws and lockwashers mate
with the keyhole slots in the downlight
fitter assembly. Make sure that all wires
and wire connectors are positioned
within the downlight fitter assembly.
Rotate the downlight fitter assembly
clockwise and tighten the two screws.
Install the other M4 x 8mm oval head
screw and lockwasher in the remaining
hole in the downlight fitter assembly.
WARNING
!
Make sure there are no wires pinched
between the light fitter and the fitter
adapter plate.
DOWNLIGHT
FITTER
ASSEMBLY
TAB
FLAT
AREA
Figure 14
10. Screw in two 60-watt (maximum)
candelabra bulbs (not supplied) in the
light fitter sockets (Figure 14).
11. Place the lower glass bowl into the
downlight fitter, aligning the three flat
areas on the glass bowl flange with
the three tabs on the downlight fitter
(Figure 14). Then turn the lower glass
bowl clockwise until the glass bowl
stops turning.
12. Your ceiling fan is now installed and
wired to be controlled by your SW101
Fan/Light Wall Control.
Page 11
Operating Your
Fan installation must be completed,
including the installation of the fan
blades, before testing of the remote
control.
Your Fan/Light Wall Control (Figure 15)
has full control of your fan and lights.
However, airflow direction is controlled by
a slide switch on the switch housing.
1. Restore electrical power to the outlet
box by turning the electricity on at the
service panel.
NOTE: Make sure that the ON/OFF slide
switch on the Fan/Light Wall Control is
in the ON position.
2. To set the desired fan speed, press the
HI, MED, or LOW buttons to operate
INSTALL THREE
your fan on high, medium, or low speed
M4 x 8mm OVAL
(Figure 15).
HEAD SCREWS
AND
3. To turn your fan off, press the OFF
LOCKWASHERS
button.
4. To set the level of light brightness,
press and hold the LIGHT button. The
60-WATT (MAX.)
light brightness
CANDELABRA
BULB (2) increase then decrease while the
button is held down. When the lights
LOWER
are at the desired brightness, release
GLASS
the button.
BOWL
5. To turn the lights on and off, press and
release the LIGHT button. The lights
will turn on at the light level previously
set (see step 4).
6. If airflow is desired in the opposite
direction, turn the fan off and wait for
the blades to stop turning. Then slide
the reversing switch (on the motor and
housing uplight assembly) to the
opposite position (Figure 16) and turn
the fan on again. The blades will turn in
the opposite direction and reverse the
airflow.
11
Ceiling Fan
IMPORTANT
will continue to