Your Ceiling Fan How To Hang - Emerson BANFF CF720ORB00 Owner's Manual

BP7309 BANFF 1/5/06 9:59 AM
INSTALL THREE M4 x 12mm
PAN HEAD SCREWS AND
RUBBER WASHERS
15-WATT
(MAX.)
CANDELABRA
BULBS (4)
Figure 5
9. Screw in four 15-watt (maximum)
candelabra bulbs (not supplied) in the
motor and housing uplight assembly
sockets (Figure 5).
10. Place the ceiling canopy over the
downrod. Then reinstall the hanger
ball (Figure 6) on the downrod as
follows. Route the three 80" motor
leads through the hanger ball and
slide the hanger ball over the
downrod. Position the pin through the
two holes in the downrod and align
the hanger ball so the pin is captured
in the groove in the top of the hanger
ball. Pull the hanger ball up tight
against the pin and securely tighten
the setscrew in the hanger ball. A
loose setscrew could create fan
wobble.
PIN
HANGER
BALL
CEILING
CANOPY
Figure 6
Page 7
11. The fan comes with blue, black and
white leads that are 80" long. Before
installing
approximately 6 to 9-inches above
top of hanger ball/downrod assembly.
Cut off excess leads and strip back
insulation 1/2" from end of leads.
12. You have now completed the initial
assembly of your new ceiling fan. You
UPPER
can now proceed with hanging and
GLASS
wiring your fan.
MOTOR
AND
HOUSING
UPLIGHT
ASSEMBLY How to Hang
Your Ceiling Fan
!
The fan must be hung with at least 7'
of clearance from floor to blades
(Figure 7).
AT
LEAST
7'
Figure 7
!
The outlet box and joist must be
securely mounted and capable of
SETSCREW
supporting at least 50 lbs. Use only a
U.L. outlet box listed as "Acceptable
for Fan Support".
DOWNROD
7
the fan, measure up
WARNING
CEILING
FLOOR
WARNING