Troubleshooting - Emerson BANFF CF720ORB00 Owner's Manual

BP7309 BANFF 1/5/06 9:59 AM
WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX
!
OR CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN.
TROUBLE
1. Fan will not 1. Fuse or circuit breaker
start.
2. Loose power line
3. Fan/Light Wall Control is OFF.
4. Code switches in remote
2. Fan sounds 1. Blades not attached to fan.
noisy.
2. Screws securing fan blade
3. Screws holding blades to
4. Loose screws in motor housing. 4. Check to make sure all screws
3. Fan wobbles 1. Setscrews in motor coupling are 1. Tighten setscrews securely.
excessively.
2. Setscrew in the hanger ball/
3. Screws securing fan blade
4. Fan blade flanges not seated
5. Hanger bracket and/or ceiling
6. Fan blades out of balance.
Page 13
Trouble Shooting
PROBABLE CAUSE
blown.
connections to the fan.
control receiver and Fan/Light
Wall Control are not set in the
same position.
flanges to motor are loose.
flanges are loose.
not tightened securely.
downrod assembly is loose.
flanges to motor are loose.
properly.
outlet box is not securely
fastened.
13
SUGGESTED REMEDY
1. Check main and branch
circuit fuses or circuit breakers.
WARNING: Make sure
!
main power is turned off.
2. Check line power connections
to fan.
3. Turn ON Fan/Light Wall Control.
4. Check that both code switches
are set in the same positions.
1. Attach blades to fan before
operating.
2. Check to make sure the screws
which attach the blade flanges
to the motor are tight.
3. Tighten screws securely.
WARNING: Make sure main
!
power is turned off.
in motor housing are snug
(not over-tight)
2. Tighten the setscrew in the
hanger ball/downrod assembly.
3. Check to be sure screws which
attach the fan blade flanges
to the motor are tight.
4. Check to be sure that the
screws securing the fan
blade flanges seat firmly.
5. Tighten the hanger bracket
screws to the outlet box, and/or
secure outlet box.
6. Interchanging an adjacent (side
by-side) blade pair can
redistribute the weight and result
in smoother operation.
Or use supplied balancing kit to
balance blades.