How To Assemble Your Ceiling Fan - Emerson BANFF CF720ORB00 Owner's Manual

BP7309 BANFF 1/5/06 9:59 AM
Ceiling Fan Procedures
General
Your Emerson ceiling fan comes supplied
with a SW101 Fan/Light Wall Control and
a Remote Control Receiver. This system
allows you to regulate your ceiling fan
speed and light intensity.
NOTE: An optional Emerson Electric
SR100 Remote Control may also be
used to control your ceiling fan.
How to Assemble Your
Ceiling Fan
WARNING
!
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse or circuit breaker box before wiring.
All wiring must be in accordance with
National and Local codes and the ceiling
fan must be properly grounded as a
precaution against possible electrical
shock.
IMPORTANT: Before assembling your
ceiling fan, refer to the Owner's Manual
supplied with the SW101 Fan/Light Wall
Control and set
frequency of the fan/light wall control
and the Remote Control Receiver.
Also, install the fan/light wall control in
the wall box as described in the wall
control Owner's Manual. You are now
ready to proceed with the assembly
and installation of your ceiling fan.
1. Mount the fan blades to the blade
flanges using three M5 x 6mm slotted
Phillips washer head screws (Figure 1).
WARNING
!
To reduce the risk of personal injury, do
not bend the blade flange when installing
the blade flanges, balancing the blades or
cleaning the fan. Do not insert foreign
objects in between rotating fan blades.
Page 5
M5 x 6mm SLOTTED PHILLIPS
WASHER HEAD SCREWS (3)
Figure 1
2. Rotate the motor and housing uplight
assembly so that one of the flange slots
in the motor and housing uplight
assembly lines up below the access
cutout in the motor and housing uplight
assembly (Figure 2). Insert the blade
flange through the slot and line up the
holes in the flange with the threaded
holes in the motor and housing uplight
assembly .
the operating
M5 x 16mm OVAL HEAD SCREWS (2)
Figure 2
To reduce the risk of personal injury, do
not bend the blade flange when installing
the blade flanges, balancing the blades or
cleaning the fan. Do not insert foreign
objects in between rotating fan blades.
5
FAN
BLADE
BLADE FLANGE
MOTOR AND
HOUSING
UPLIGHT
ASSEMBLY
ACCESS
CUTOUT
BLADE
FLANGE
FLANGE
SLOT
WARNING
!