Advertisement
STEP 7
ATTACH BASE TO CABINET
Tools Required: 8mm Hex Wrench
Hardware Required: Four M10 x 25 socket head bolts, four M10
lock washers and four M10 flat washers (Hardware bag #4).
•
Place dust chute over the cabinet as shown. Make sure
the holes in the corners are aligned with the slots in the
dust chute.
Figure 12
•
Place the base assembly over the dust chute and secure
the base assembly to the cabinet using the flat washers,
lock washers and bolts.
•
Secure all fasteners in the base assembly fully tight.
Figure 13
STEP 8
ATTACH RIP FENCE BRACKETS
Tools Required: 4mm Hex Wrench
Hardware Required: Two M6 x 16 socket head bolts, two M6
flat washers and two M6 hex nuts (Hardware bag #4).
Install the rip fence storage brackets to the right side panel of
the base using two screws, flat washers and hex nuts.
Figure 14
BLADE GUARD AND PUSH STICK STORAGE
BRACKETS
Tools Required: Phillips screwdriver and 4mm hex wrench
Hardware Required: Four M3 x 10 pan head screws, four M3
lock washers, four M3 flat washers, four M5 x 12 socket head
bolts, four M5 lock washers and four M5 flat washers
(Hardware bag #4).
•
Install the push stick storage brackets to the left side panel
of the base using four screws, lock washers and flat wash-
ers.
•
Install the blade guard storage brackets to the left side
panel of the base using four screws, lock washers and flat
washers.
•
Press the four rubber feet to the base legs.
•
Turn the saw upright.
Rubber Feet
Figure 15
5
STEP 9
Blade Guard
Bracket
Push Stick
Bracket
Advertisement
