•
Refer to Figure 7; loosen and remove the bolt and hex nut
from the support. Rotate foot pedal bar so that kick plate
cam is inside bracket. The kick plate cam must be under-
neath the caster to function properly.
Figure 7
•
Refer to Figure 8 and 9; place caster onto the support and
secure in position with bolt and hex nut.
Figure 8
Figure 9
•
Repeat above steps for the second caster set.
ATTACH CASTER SETS TO BASE
Tools Required: 5mm Hex Wrench
Hardware Required: Eight M8 x 16 socket pan head bolts
(Hardware bag #4).
•
Attach one caster set to the two front corner supports
using four M8 x 16 socket pan head bolts.
•
Attach the remaining caster set to the two rear corner
supports.
Figure 10
ATTACH LINE CORD HOOKS
Tools Required: 4mm Hex Wrench
Hardware Required: Two M6 x 16 socket pan head screws,
two M6 flat washers and two M6 hex nuts (Hardware bag #4).
•
Insert a screw into a line cord hook and place against the
holes on the left side of the saw cabinet.
•
Secure hook in position using flat washer and hex nut.
•
Repeat for other hook.
Figure 11
4
STEP 5
STEP 6