Advertisement
STEP 2
•
Use the blade tilt handwheel to tilt the blade completely to
45°.
•
Remove the packing material from behind the motor.
•
Return blade to the 0° position.
Figure 3
STEP 3
ASSEMBLE MOBILE BASE PANELS
Tools Required: 4mm Hex Wrench
Hardware Required: Twenty-four M6 x 12 socket pan head
bolts (Hardware bag #4).
•
Attach the front panel between the two corner supports
using six M6 x 12 socket pan head bolts.
Note: Place the panel edges INSIDE the corner support
surfaces.
Note: Front panel and rear panel are both stamped 'A'.
Front panel has warning label.
•
Repeat above step for the rear panel.
Letter Stamp On Top Edge
Figure 4
Remove this
packing material
•
Set both panel assemblies upside down on bench and
attach the left side panel (stamped 'B') to the assemblies
made above.
•
Attach the right side panel (stamped 'C') to the assembly.
Below is completed base assembly.
C
Figure 5
ASSEMBLE CASTER SETS
" Open End Wrenches
Tools Required: Two
⁄
1
2
•
Refer to Figure 6; remove casters (4) and supports (2)
from carton.
Bracket
Kick Plate Cam
Figure 6
3
A
B
A
STEP 4
Advertisement
