Table of Contents
Advertisement
IMAGE Menu
IMAGE Menu
With the IMAGE menu, items shown in the table below can
be performed.
on the projector or remote control, or the ENTER button
on the remote control to execute the item. Then perform it
referring to the following table.
Item
ASPECT
OVER SCAN
V POSITION
H POSITION
H PHASE
30
For an RGB signal
NORMAL
4:3
For a video signal, s-video signal or component video signal
4:3
16:9
14:9
For a no signal
• The NORMAL mode keeps the original aspect ratio of the signal.
Large (It reduces picture)
• This item can be selected only for a video, s-video and component signal.
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In such a case, please adjust small.
Up
Down
• Over-adjusting the vertical position may cause noise to appear
on the screen. If this occurs please reset the vertical position to the
default setting. Pressing the RESET button when V POSITION is
selected will reset the V POSITION to the default setting.
For a video signal, s-video signal or component video signal
The adjustable range of V.POSITION depends on the OVERSCAN setting.
It is not possible to adjust when the OVERSCAN is set to 10.
Left
Right
• Over-adjusting the horizontal position may cause noise to appear
on the screen. If this occurs please reset the horizontal position to
the default setting. Pressing the RESET button when H POSITION
is selected will reset the H POSITION to the default setting.
For a video signal, s-video signal or component video signal
The adjustable range of H.POSITION depends on the OVERSCAN setting.
It is not possible to adjust when the OVERSCAN is set to 10.
Right
Left
• This item can be selected only for an RGB signal or a component
video signal.
Description
16:9
SMALL
SMALL
Hide quick links:
Advertisement
Table of Contents
