Command Control via the Network
Command Control via the Network
commands.
Communication Port
The following two ports are assigned for the command control.
NOTE
• Command control is not available via communication port (TCP
Command Control Settings
Example: If the IP address of the projector is set to 192.168.1.10:
1) Enter [https://192.168.1.10] into the address bar of the web browser.
2) Enter the Administrator ID and Password and click [Logon].
[Port settings] on the main menu.
4) Click the [Enable] check box to open
authentication is required, otherwise clear the check box.
[Enable] check box to open
when authentication is required, otherwise clear the check box.
[Apply] button to save the settings.
[Enable] check box for the [Authentication] setting when
[Enable] check box for the [Authentication] setting
(
9)
to use
to