Stacking Instructions For Stacking Kit 29757 - Cornelius SERIES 750 (R404a Service Manual

STACKING INSTRUCTIONS FOR STACKING KIT 29757

The Kit consists of:
1 – #26102 Sealer
2 – #261 1/4-20x5/8 screw
2 – #256 1/4" flat washer
2 – #239 1/4" Lock Washer
1 – #29758 Stacking Chute Extension
1. After uncrating machine to be stacked, remove front and rear panels.
2. Remove top and front panels of bottom machine.
3. Remove alternate chute opening cover from bottom machine.
4. Insert vertical chute extension from kit into alternate chute opening of bottom unit and seal it to the base
with sealer provided in the kit.
5. Carefully mount stacking unit reversed 180° with the compressor and condenser opposite those of the
bottom unit.
NOTE: When mounting, make sure stacking unit vertical chute aligns and inserts correctly with chute
extension installed in alternate chute opening of bottom unit. Raise chute bracket to cover
opening and tighten bracket screws.
6. Secure both machines together as shown in the illustration utilizing screws and washers provided in the kit.
7. After stacking unit, hook up electrical and water.
NOTE: The two units must operate independently of each other.
8. Connect drain line from tee under the stacked unit to run out of the back of the unit.
9. Replace panels of stacked unit front to front and back to back as the machine is mounted. Replace front
panel of bottom unit.
166240009
8