Installation Instructions; Location Of Equipment; Baffle Installation - Cornelius Xtreme ICE Series Owner's/Operator's Manual

Installation and start-up of the equipment should be performed by the distributor or the dealer's professional
staff.

LOCATION OF EQUIPMENT

For maximum performance the location should be away from heat sources such as ovens, direct sunlight, hot
air discharge, etc.
To reduce cost of maintenance and loss of efficiency, avoid placing air-cooled equipment in areas where grease,
flour and other airborne contaminants are present. Allow a minimum of 6I (15.24 cm) clearance at the rear and
right side for proper air circulation. Restricted air circulation will affect the efficiency and required maintenance of
the product.
IMPORTANT: Never operate your equipment in room temperature below 50_F (10_) or above 100_F
(38_C). Should the location of your product ever be exposed to freezing temperatures, it must be shut
down and winterized.

Baffle Installation

NOTE: The baffle is only used on the 1030, 1230, 1444, and 1844.
The baffle must be used when the right hand side of the icemaker is installed in a corner. This will prevent dis-
charge air from recirculating to the condenser.
1. Loosen three screws, as shown in Fig. 1.
2. Install baffle, as shown in Fig. 1. with paper towards the front of the unit.
3. Tighten the three screws.
December 22, 2005

INSTALLATION INSTRUCTIONS

FIG. 1
5
630460146OPR