Table of Contents
Advertisement
1. Locate the dispenser indoors on a level counter top. Unpack the four (4) legs and install them into the
threaded holes provided in the bottom of the unit.
2. Connect the 3/4? IPS (or equal) drain line to the 3/4? threaded drain connections at the lower rear of the
unit. This line must pitch downward to an open drain and must contain no traps, or improper drainage
will result.
3. Clean the hopper interior. (See CLEANING INSTRUCTIONS.)
4. Connect the power cord to a 120 volt, 60 hertz, 3-wire grounded receptacle. All electrical wiring must
conform to national and local electrical codes.
NOTE: Page 6 provides mounting templates for those who desire to mount dispensers on a counter.
CAUTION: Disconnect power to dispenser before installing, removing or adjusting
restrictor.
This dispenser is provided with a gate restrictor plate, installed in it' s highest position. This plate adjusts the rate
of ice flow from the dispenser. In applications using buckets, carafes or other large containers, the plate may be
removed entirely for maximum ice flow. For glasses and cups, the plate may be adjusted downward to reduce
the flow of ice. The best position depends on the type of ice being used and the size container and must be
found by trial and error. Adjustment is made by loosening the upper two ice chute retaining nuts, sliding the
restrictor plate to the desired position and re-tightening the nuts.
If the dispenser fails to dispense the ice when operated, check that the hopper has ice in it and that power is
being supplied to the unit. If the problem persists check the following:
1. Determine if the agitator is rotating (check for the sound of ice movement in the hopper).
2. Observe whether the gate is opening.
91718
INSTALLATION INSTRUCTIONS
FIGURE 1. GATE RESTRICTOR PLATE
ADJUSTMENT
INSTALL PLATE
ON STUDS AS SHOWN
2
Advertisement
Table of Contents
