Clarity E814 User Manual page 37

CorDless hanDseT insTallaTion
step 1: Connecting the charging base station
• Locate the charging station (a) in close proximity to the corded base station and plug
the power supply cord into an electrical outlet.
step 2: install rechargeable batteries
• Remove the battery compartment cover (b) by pushing down with thumb and sliding
the cover towards the rear of the handset.
• Insert the batteries (c) by aligning the positive and negative end of batteries with the
appropriate matching battery compartment contacts. Positive contact (+) to the flat
contact of the battery compartment, and negative contact (–) to the spring contact
of compartment.
• Replace the battery compartment cover by sliding and pushing upward with thumb
until the cover snaps into place.
step 3: insert handset on base to charge batteries
• Position the handset on the charging base and charge for 16 hours first time.
A beep indicates that the handset is properly placed on the base or charger.
note: Use only nimh rechargeable batteries. Please refer to the Battery
Safety Instructions on page 5 for proper use and disposal of the batteries.
(Purchased separately)
a
c
b
37